���˴�Ƭ

1. Introduction and Definitions:

To identify the genotype of a mouse, tissue is biopsied to extract the genomic DNA. Tissue is harvested between 14-17 days of age to help minimize any pain or stress associated with the biopsy procedure. Ear notching (ear punch) or removing the most distal portion of the tail are the methods most commonly used. Carefully designed breeding strategies and accurate genotype assessment can help to minimize the generation of animals with unwanted genotypes. Once the genotype has been determined, animal colony populations can be maintained at reduced animal numbers necessary for experimental efficiency. Genotyping should be completed after d14 and before the animal is weaned (d21). This enables the user to cull or donate animals that are not of the genotype sought, and saves the generation of a cage card.

• Ear biopsy can be done up to d21without anesthesia and/or analgesia, however after d17, anesthesia and analgesia must be provided to animals undergoing a tail snip. 
• Researchers should remove the least amount of tissue necessary to perform genotyping. 
• If animal identification is being performed through the removal of a piece of tissue, the same sample of removed tissue should be used for genotyping purposes. 

2. Materials:

• Ear notch instrument 
• Fine tipped forceps 
• Iris scissors 
• Sterile scalpel blade 
• Sterile gauze 
• 70% isopropyl alcohol or 
• Hydrogen peroxide and peracetic acid solution (HP-PA) 
• Bead sterilizer 
• Ruler 
• Anesthetics as required 
• Analgesics as required 
• Collection tubes 
• Styptic powder and/or silver nitrate sticks 

3. Procedures

Ear Punch Method

• The procedure is quick, easy, and should not cause bleeding if done properly. If bleeding does occur, apply gentle pressure with gauze until hemostasis occurs. 
• This technique is best performed at 14-21 days of age. 
• Instruments used for ear notching can become dull after use and should be replaced often, as dull instruments can cause trauma to the notch site. 
• Ensure the ear notch tool is clean of debris and disinfected with alcohol or an HP-PA solution between each and every animal to prevent DNA contamination. Restrain animal using the scruff technique (as per SOP 7.20 “Manual Restraint of Mice”). 
• Place the device on the pinna of the ear (external ear) in the location wanted to mark the animal for identification. 
• Press firmly to punch a circular hole through the ear (as indicated on the diagram below). 
• As you remove the punch, be careful not to rip the delicate membrane of the pinna. If the punch does not remove all tissue, use forceps to gently hold the remaining skin tag and carefully cut free using iris scissors. 
• For full circle numeration, ensure the hole is punched ~2mm in from the edge of the ear. This will prevent the hole from tearing, and possible misidentification with a semi-circle. 
• Place the animal back in cage. 
• Record animal’s information on its respective cage card. 

Distal Tail Snip Method

Recent studies have proven that tail snips can cause hypersensitivity even six months after the tail has been snipped. The last 5mm of the tail has tendons, nerves and coccygeal vertebrae that partly ossify by the age of 17 days. In a pre-weanling mouse, the distal 2mm tail does not contain mature vertebrae (bone), thus, the tail biopsy should be performed at as young of an age as is feasible. With increasing age, tail maturation includes mineralization of bone and increased vascularity; it has been demonstrated that tail biopsy sampling performed on older mice (> 28 days) can result in prolonged discomfort.

• General anesthesia and analgesia is required when tail biopsy is performed on animals older than 
• 17 days of age. 
• If general anesthesia (refer to SOP 7.6) has been administered, the mouse must have fluid therapy provided, and be observed until it regains mobility. 
• The maximum amount of tissue to be removed is one 3mm tail snip for polymerase chain reaction (PCR), or one 5mm tail snip for Southern blot analysis. The maximum number of tail snips that can be performed is one. If additional genotyping is required, an ear punch, fecal pellet, hair follicle or buccal swab must be used. 
• Ensure the blade or scissors are clean of debris and disinfected with alcohol or an HP-PA solution between each and every animal to prevent DNA contamination. 
• Restrain the animal using the scruff technique or restrain the animal and rest it on a flat, clean surface. 
• Wipe the tail with 70% alcohol. 
• Grasp the tail and referencing your ruler (laid flat), measure ≤ 3 or 5mm. 
• Using either clean sharp iris scissors or a clean scalpel blade, cut the distal portion of the tail in one fluid motion. 
• Any bleeding at the tail tip must be controlled following the biopsy. Hemostasis can usually be achieved by direct manual pressure with gauze on the end of the tail. If direct pressure does not stop the bleeding, the use of hemostatic agents (e.g. Styptic powder such as KwikStop ®) is recommended and should be readily available as a precautionary measure. 
• Return the animal to its home cage only once all signs of bleeding have stopped. 
• Document procedure on the cage card.